TAB buses driver guide

This guide should enable you to drive for TAB buses as part of your use of the Fernbus simulator from TML Studios.

In general, you use Fernbus in exactly the same way that you normally would.  The main difference is that you need to create routes in Fernbus to match the routes that you choose to drive from the TAB route list on the "Routes" page.  You will then need to take screenshots of the Fernbus results pages and keep them for a short time.  

​

You then need to submit your results using the form on the "Contact" page stating your username, hub and route, and the numbers for the following items from the Fernbus results:

Total passengers, Tickets sold, Invalid check-ins, Distance (km), Stops completed, On time departures, On time arrivals, Accidents and Radar traps.  An example would be 30, 2, 0, 218, 4, 3, 4, 0, 0.  You only need to submit the relevant numbers separated by commas as shown here.  As long as the numbers are in the correct order, you do not need to also type the categories...just the figures will be sufficient if they are in the correct order and separated by commas.

Once the route has been submitted, it will have a status of "submitted" on the "Submitted routes" page on this site, although it will not appear immediately.  It will, in most cases, then change quite quickly to "accepted" but to ensure fairness a random selection of routes will be made for which screenshots will be required.  In such a case, the route will not change to "accepted" until the screenshots have been reviewed and if screenshots are not received within 48 hours, the route will be deleted.

All accepted routes will then form part of the statistics for driver progress and will therefore be included in the charts and tables on this site through which drivers can see how they compare to others, and advance in rank within the company (see the "rank within the company" page)

​